Metalix 3

A new addition to the metal level series. Metal stairs always make things interesting, as does the necessity of rounded corner blocks. So be careful with the

Spoiler: Tricks

Autopilot, cancel tap, SBS

Was the last move this?

Spoiler

With B on the upper surface, tap above the win and lower lift, B doesn't go so lower again so the rounded corner lets B somewhat make the corner and then raise so B runs over the rails?

@Meko Guy

Spoiler

Yes, the metal and round edges complicate the last autopilot, so you have to lower the slider an extra block down so B scrambles over the rails to the win.

@Don G Rowe - An awkward move in my books as it took B a few attempts to get the eye around the corner and then moving up to the square to give the finally nudge - unless I did it wrong.

@Meko Guy Did you do it like this?

Spoiler: movie

@Don G Rowe - Just like that but my B took way longer (like 30 seconds), just tried it again and the same thing. B tends to look for the spot as B stands there and one must move up quickly when B starts to see the corner otherwise it takes longer.

@Don G Rowe - I was just thinking that my level called 'Auto Pilots' posted yesterday has the same (similar move) but I used wedges instead of pillars and B goes very easily - a rail since it's smaller may work better too.

Enjoyable level. My finish was different and more relable.

Spoiler: Longcut

Instead of tapping block above winblock, just tap the corner block. B moves two blocks and stops on the rail. Tap winblock.

@ridgerunner - Good point

Fun level...I did the last step different,I mean...Autopilot (Tap on the right corner,cancel tap and win)Thanks for sharing @Don G Rowe

@delator77 ..autopilot... I found the cancel tap is not required if B is not dropped level with the blocks. Let B drop a bit first.

Spoiler: No tap finish

Pretty easy if you know the tricks... though as usual I'm not the fastest tapper, so that last auto needed a couple of attempts so I could get B dragged down to the proper place (he left the draggable before I could move it). Strange design, though, and maybe a little too monochrome.

So I need to ask - how did you get the metal stairs? With Mekostudio? Because there's no tag on the card.

I did it with Meko Customizer, but didn't select the "force optimized QR code" option.

@Don G Rowe Ah, okay. That's the only thing I've used Mekostudio for so far is to optimize the QR code.

Very nice level. I see that I am not the only one who had a problem with the final step.