Gear City

Wow - your levels are so annoying.... I'm not going to be spending much time on them from here on in as I'm wasting too much time and not accomplishing a win. What I didn't like about this one:
A little hidden, I assume tricks are required but you didn't say so - I needed a SBS (long and short) for starters. The right corner spinning mechanism caused B to land on the wedges more than 50% of the time and B needed to do that device twice so it was a good chance that B wasn't going to win. The Randomness of the mechanism on the other side caused B to land on the surface often. Aside from that - I seen the game play but wasn't lucky with your mechanisms. The one on the left stopped sometimes as well. So way too many restarts to not accomplish a win. Maybe, you should consider recovery points. For example, B got stuck on the right mechanism (wedge) three times on the way to the win.

@gmacpro Thanks for playing and thank you for your advice. I'd like to revise this level, but it may be difficult for me. A few months ago, my device broke down and I had to download the game again, but the level I created disappeared. Fortunately, before that, I stored these levels of photos in one of my albums, so now I can still publish them, but I can't make any changes. (Maybe I can, but it takes a lot of steps. I need to copy a level as it is before I make a change.) If I can, I may change the slope on the left side of the right staircase to a staircase so that B can go straight up to the top.

Some nice design ideas, but just to unstable. B keeps falling from the level. I was almost done but then he fell at the last wheel.

@huijiuggbf - You can load your QR codes into MekoStudio.com - 3D Builder and edit them.

It was a challenge to overcome but not enjoyable enough to merit more than 4*. There were lots of little tips collected along the way- one nasty claustrophobia effect especially. With B having a tendency to shoot backwards off the last wheel , i won by using a slightly different method using the last mesh.

@Block builder @ridgerunner Thnaks for playing! @gmacpro I tried, but I couldn't open it.

@huijiuggbf .. Is this a shortcut or the designed ending?

Spoiler

@ridgerunner Sorry, I can't open it.

@ridgerunner - That works. I put B on the spinner in the opposite direction then using the slider underneath rotated the spinner so B would go over to the other side but your way is more stable.